Below you will find an in depth video installation guide for the AquaYouth 2.0 shower filter. Be sure to watch the entire video and feel free to pause it and playback parts of it as you install your unit.

Register Your Product:

After purchasing, don't forget to register your product to get access to your product warranty benefits, exclusive coupons, enhanced customer support, etc. To register your product, please visit: www.AquaYouth.com/Register

Tools & supplies that you will need:

Thread seal tape (included)

Adjustable wrench

Step 1: Detach your current shower head.

Remove the existing shower head from the shower arm by turning it counter-clockwise OR if you have a hand shower, remove the shower mount from the shower arm

Step 2: Clean & Dry The Shower Arm

Clean any excess material from the shower arm threads and dry any moisture with a towel.

Step 3: Wrap shower arm with thread seal tape (3 to 4 times around, clockwise)

Wrap plumbers tape around the threads 3-4 times in the clockwise direction. If you wrap it the wrong direction, it can come undone as you screw on the shower head and may cause leaking.

Step 4: Attach the thicker end of the connector to the shower filter

Attach the thicker end of the connector to the shower filter.

Note: Pay attention to the "in" and "out" arrow indicators on the shower filter. The "in" side gets attached to the shower arm. The "out" side will be attached to the shower head.

Note 2: The connector comes with two black washers. Please make sure that you place a black washer in each end of the connector to ensure that it doesn't leak.

Note 3: The connector contains two metal screws that can move independently, one end is thicker than the other. Connect the thicker end of the connector to the shower filter's "in" side

Step 5: Attach the thinner end of the connector to the shower arm

Attach the thinner end of the connector to the shower arm.

Step 6: Reattach the shower head to the shower filter

Attach the shower head or shower mount on to the shower filter and hand tighten the shower to the shower filter by turning it clockwise.

Step 7: Flush for 2 minutes to remove fine dust.

Run the water for 2 minutes to flush fine dust. Then you're ready to shower.

Congratulations, the installation is complete. If you haven't already, make sure to register your product.

After purchasing, don't forget to register your product to get access to your product warranty benefits, exclusive coupons, enhanced customer support, etc. To register your product, please visit: www.AquaYouth.com/Register